I made leaf spring shoes. When I made leaf retainers, they deformed pressed by a cutter. This time I held the work bit deep in the vice jaws to prevent it.. Obviously slotting saw could not be used and end mills were used.

担いバネ受けを作る。バネ押えを作った時切り込みを入れたところが外に拡がってしまったので今回はバイスに深めに咥え、広がるのを防止することにした。当然すり割りフライスは使えないのでエンドミルで溝を掘る。

The cross section of the work was like this.

こんな断面のものができる。

Parts were cut out.

これから部品を切り出す。

12 shoes were cut out.

12個作った。

They were soldered at both sides of the pedestals.

ペデスタルの両側にハンダ付け。

The frame sits on the spring as this (upside down).

バネの両端にこのように乗るわけだ。


 

 
inserted by FC2 system