I made pistons from 12mm brass rod. The movement of the pistons of ERIC was bit tight. This time I decided to make compression ratio of the O-rings 5%. The nominal pressure of the loco to be 40psi and I think 5% of compression should be enough.
ピストンを作る。φ12の真鍮丸棒を削る。ERICのピストンの動きがかなりきつかったので、今回はOリング5%圧縮としてピストンリング溝の深さを決定した。どうせ常用圧力40psi(2.75Bar)なので問題なかろう。