I made end beam supports from 5X5mm brass square rod.
端梁受けを5X5mmの真鍮角棒から作る。
I temporarily fixed them to the frame with brass M2 screws and soldered them by a blow torch.
端梁受けは台枠にM2の真鍮ビスで仮止めした後バーナーでハンダ付け。
Some screw were soldered and I removed them by mill.
ハンダが廻ってしまったビスの頭はフライスで削りとった。
Wheels and water pump were mounted.
給水ポンプを付けて組み立ててみる。
I felt the thickness of the tyre of the wheels were bit too thin as a narrow gauge stock, but decided not to care.
車輪のタイヤが軽便にしては薄すぎる感じがするが気にしないことにする。
Water feed piping arrangement. They just settled between the frame and axle.
給水ホースの取り回しはこんな感じ。車軸ギリギリでおさまた。