I made crank pins for coupled cranks from 6mm SUS303 rod. Firstly I turned them as this.

第一動輪のクランクピンを作ります。6mmのSUS303をこのように削り。

Then I threaded M2.6 at 2.6mm diameter part.

2.6mmのところにM2.6のダイスを切ります。

Parted piece.

これを突っ切ればこんなものができるわけです。

I needed to cut the head of pins in hexagon, and made a fixture from 10mm hex brass rod. The centre of the rod had a M2.6 tap.

上記の部品の頭を六角にするためにヤトイを作ります。10mmの六角真鍮棒の一端にM2.6のタップを立てたものです。

I fixed the fixture to the mill vice and cut flat parts of hexagon by rotating the hexagon fixture.

これをフライス盤のバイスに咥えて一辺づつ回しながら、ボルトヘッドを六角に削りました。

Mistake

I moved the parts mounted on the fixture to the lathe and cleaned up the end and chamfered it. Arrowed one was a failed because I did not tighten it enough to the fixture and it moved while milling.

失敗

これを旋盤に移して端面をきれいにし面取りをすれば完成です。矢印のものは六角切削中にさらにねじが締まってしまい失敗したものです。写真ではよくわかりませんが六角が均等になっていません。

Pins for driving cranks were simply straight rods. They were cut out from 3mm SUS303 rod and bonded to the cranks by Locktite 638.

主動輪のクランクピンはただの棒なので簡単です。SUS303の3mm棒から作りLocktite 638でクランクに接着。


 

 
inserted by FC2 system