I made a valve of safety valve.

安全弁のバルブを作ります。ようはこんなものを作るわけです。

I made a blind hole fitted to the ball diameter to a piece of brass rod. Then I inserted a ball and measured the distance between edge of the brass rod and top of the ball. This dimension is important according to the Kozo's book.

まずは真鍮丸棒にボールに合うめくら穴をあけ、ボールの先端と真鍮棒の端との距離が重要らしいのでこのようにして測ります。

I turned the end of the brass rod as required. I forgot to take a photo of finished ball holder.

規定値に真鍮棒の端面を切削。この後、外形を削りますが、出来上がりの写真を撮り忘れた。

Required spindle material was 1.2mm SUS rod, but I did not have this size. So I turned 2mm SUS303 rod down to 1.2mm. This job was very hard. This photo shows first attempt ended as failure. The end of the rod was too thick.

スピンドルは1.2mm径なんですが、手持ちに1.2mmのSUS棒がなかったので、2mmのSUS303から削り出すことにしました。難しい。これは一回目の失敗作。先端が太くなってしまった。

I could manage to make reasonably good one on the second attempt. I polished lightly the surface with oil stone, and parted off by a file.

二回目でなんとか使い物になるものができました。一応、油砥石で表面をきれいにしておきます。このくらいの細さになると、バイトでの突っ切りはできないので、ヤスリで切り落としました。

Taper of the end of the spindle was made by file. ER25 collet could not hold 1.2mm rod. So I used precision key-less chuck.

先端にヤスリでテーパーを入れているところです。ER25のコレットでは1.2mmはくわえられないので、コレットにくわえた精密キーレスチャックで保持。

All parts were assembled by Loctite.

できた部品をロックタイトで接着すればバルブの出来上がり。


 

 
inserted by FC2 system