|
I bought a 5/16'' parting off blade and made a holder for it. I cleaned up 16X16mm black skin steal bar and cut slots. The structure is about the same as “Hacksaw Blade Parting Off Tool”.
5/16"(約8mm)の突っ切りバイトを手に入れたのでホルダーを作ることにしました。15X15に仕上げた軟鋼角棒にすり割りフライスで切れ目を入れます。構造は「鋸刃突っ切りバイト」と大体同じです。
|
|
The groove that accepts the blade was cut. The blade had a taper. So the bottom of the groove was angled.
バイトの収まる部分を切削。バイトにテーパーが付いているのでその半分の角度をつけてあります。
|
|
I adjusted the depth of the groove until the blade sat nicely.
バイトがすんなり収まればOKです。
|
|
The cross section of the groove is like this.
断面はこんな感じになるわけですね。
|
|
I cut deep slot remaining about 1.5mm.
さらにホルダーには深い切れ目を入れます。
|
|
I installed tightening bolts (M3) to hold the blade while grinding.
旋盤の刃物台に固定すればバイトとバイトホルダーが一緒に固定されるんですが、バイトを研ぐときにホルダーに固定したいのでM3の固定ネジをつけました。
|
|
Ground blade. The thickness is bit less than 1mm.
研ぎ終わったバイト。厚さは1mm弱。
|
|
I worked quite well to part off small parts like this brass tube.
とても良く切れ、パイプの突っ切りなどにはうってつけです。
|