I had a tap handle on hand. I converted it to a tap holder for machine tools.
手持ちのタップハンドルなんですが、これを工作機械用のタップホルダーに改造することにします。
I put the tap handle to three jaw chuck and made a starting hole with 6mm starting drill.
三つ爪チャックにタップハンドルの本体をこのように装着して。まずは6mmのスターティングドリルで芯出し。
I gradually increased the hole diameter and finished up with 6mm drill. The handles (arrow) of the tap handle sized 7mm dia. So 6mm hole should be accepted.
ドリルを徐々に大きくして行って、6mmで完了。もともとのハンドル(矢印)が7mm径なので6mmで開ければかろうじて大丈夫でしょう。
I was shaping a shaft to be inserted to the hole in the tap holder. It was made from 6mm SUS303.
タップハンドルに開けた穴に通すシャフトを6mmのSUS303から作ります。これは端面の面取りをしているところ。
Finished. It was quite easy project.
完成です。とても簡単にできました。