After I ground right hand tool, failed parting off and boring tools, the stone of the grinder was clogged. I made a diamond dresser holder. However this was unstable and did not work well. The problem was the distance between the guide cut out and lower part of the dresser.
I cooled the HSS bits with water when ground and applied them on the stone still the bits were wet. This caused the clogging. The water should be wiped out from the bits thoroughly after cooling.
.
斜剣バイトと失敗した突っ切りバイト、中繰りバイトを削ったときグラインダーの目をだいぶ詰まらせてしまいました。ドレッサーを掛けるためにこのようなホルダーを作りました。これはダメでした。ドレッサーの下端とガイドの切り込み部分に距離があるため安定せず。
なお、上記バイトを削ったとき、水で冷やしたバイトを濡れたままグラインダーで削っていました。これが目詰まりを起こした原因のようです。バイトは冷却後よく水を拭き取りましょう。