I made a fixture to turn tip of screws. It was very simple as shown on the left. One side had M2.6 tap (size of screws) and other side had M6 tap. I wanted to make a screw shown on the middle.

ねじの先端を切削するためのヤトイを作りました。左端の非常に簡単なものです。片方に削るねじのタップ、反対側にM6のタップを立ててあります。要は真ん中にあるようなねじを作りたかったわけです。

At first the screw turned to be screwed in from M6 side.

使い方は、まず切削するねじをM6タップ側からねじ込みます。

Then an M6 grab screw was tightened to prevent the screw turned from losing.

その後ろにM6のイモねじをきつくねじ込み廻り止めとします。

Then the screwed was ready to be turned.

ヤトイを付け替え、ヤトイから突き出したねじの先端を削れば一番上に示したようなねじができます。


 

 
inserted by FC2 system