|
I decided to make small parts at this stage and made the hand brake wheel at first. I looked for a cylinder with proper diameter and rounded 2mm aluminium wire around it.
ここで小物部品を作ってしまうことにしました。まずはブレーキハンドル。適当なサイズの円筒に2mmのアルミ棒を巻きつけます。
|
|
A ring was made.
こんな輪っかが出来ます。
|
|
I made spokes from styrene sheet. I made them curved.
スチロール版から切り出したスポークを付けます。まっすぐではなく曲がったスポークにしましたがもう少し派手に曲がっていたほうがいいかも。
|
|
Handle was turned from 2mm styrene rod.
取手は2mmスチロール棒より切削。
|
|
The brake was wheel finished with handle. This would be the master for resin casting.
これを上の輪っかにつければ出来上がり。例によってレジンで複製します。
|
|
Also I made brake handle support.
ブレーキハンドル・サポートも製作。
|
|
I made a ratchet wheel.
次はこんなモノを作ります。
|
|
A couple of other parts were made.
さらにいくつか部品を作り。
|
|
This is the finished brake ratchet. However I made this only from my imagination. I could not see any ratchet on the photos of prototype.
組み立てるとこのようになる。ブレーキハンドルのラチェットです。でもこれは想像だけで作った物。ウェブで見つけた井笠のホハ1の写真にはこのようなもんが見当たらない。実物ではブレーキの固定はどうやっていたんでしょうか?
|