These are the material for end panels. I laminated two scribed 1mm sheets. Planking lines are not visible here.

これは妻板の材料。板目を彫った1mmのスチロール板を2枚接着したもの。いかんピンボケだし板目がよく見えない。

Details were added. Left ones show inside and right one outside. The prototype does not have horizontal timbers, but I put them to make painting easier.

これにデテールを付けていく。左側が内側。右側が外側。プロトタイプには妻板にはシル、ヘッダーに相当するものはついていないんだが塗り分けを簡単にするためにつけることにした。

Handrail brackets were installed

ハンドレールのブラケットを付けておく。

End panels were attached to the body.

妻板を本体に取り付け。

Fixed end panels.

固定した妻板。このあとデッキ上部の化粧板を付けたんだが写真を撮り忘れた。

Gutters were made in the same way as “Gasoline Car”. At first mark a line 1mm inside the 1mm styrene.

次に雨樋を付ける。これは以前ガソを作った時と同じ方法で作った。まずは1mmのスチロール板に1mm幅をけがく。

The material filed down 1X1mm in 45 degrees. I used double-cut at first and then single-cut.

これを目安にやすりで45度の角度で削る。複目で荒削りし、単目で仕上げるときれいにできる。

Then 2mm wide strip was cu out by parallel scriber.

これをプラけびきで2mm幅に切断。

The result was this trapezium-shaped strip.

そうするとこのような台形の部材ができる。

1X3mm strips were installed at first 1mm above the side panels. Then above trapezium-shaped strips were bonded 0.5mm above. In this way reasonably realistic gutters were formed.

まずは3X1mmのスチロール帯を1mm上部にはみ出させて接着し、その上に0.5mmはみ出させて、上記の台形の部材を接着すれば結構もっともらしい雨樋が出来上がる。


 

 
inserted by FC2 system