|
I made tail light lenses by heat-pressing PVC sheet. This is the mould for heat-pressing. I turned the curve on a piece of acrylic bar with a form tool.
尾灯のレンズを作ります。塩ビのヒートプレスで作るので型を作ります。レンズ半径3mmにする予定なのでアクリル棒の先端をR3の半球状に姿バイトで削ります。
|
|
I heated up a piece of thin PVC sheet and pressed to the mould.
薄手の塩ビ板をろうそくで加熱し、柔らかくなったら型に押し当てます。
|
|
I punched out the lenses with a 5mm punch.
これを5mmのポンチで打ち抜けば、レンズができます。
|
|
Mass-produced lenses. I might loose many lenses on the way. So I made plenty.
量産したレンズ。どうせ、かなり無くしそうなので大量に作った。
|
|
I fixed the lenses to an wood piece with Blu-tack.
レンズを塗装するために割り箸にブルータックで仮止め。レンズの内側はアルコールを染み込ませた綿棒で脱脂をしておく。
|
|
I sprayed Tamiya clear red acrylic paint bit thick.
タミヤのアクリルクリアーをかなり厚めに吹きつけた。
|
|
Painted tail light lenses.
出来上がったレンズ。
|
|
The tail light parts were mass-produced by resin casting.
レジンで尾灯部品で量産。
|
|
I drilled two holes for LED leads on the end beams.
取り付けはこのように行った。まずは端梁に穴を開けてLEDの足を通す。
|
|
Then the housing was bonded to the end panel. The reflector disks are not fixed yet. They will be fixed after painting.
その上に本体を接着。反射板は塗装後に取り付け予定なのでここでは置いてみただけ。
|