I started mass production of figures. I hope I would not give it up. I would make figures for carriage no.2, assuming an excursion of small local primary school. So I need a teacher and many pupils.

This is the base of the teacher.

いよいよ、人形の大量生産に取り掛かります。途中でめげなければいいんですが。まずは弐号客車用の人形を作ります。この客車は田舎の分校の遠足の貸切と言う想定で、先生一人と子供をたくさんのせる予定です。まあ時代は違いますが二十四の瞳って感じですか?

これは先生の骨格部分。

I made five pupils. I would need about double of this number.

とりあえず、子供も五人作ります。これの倍は作らなければなりませんね。

The knapsack I made before may be too large for smaller pupils. So I made smaller one. I made the sack itself as same as before and added string made from stretched clay adhered by “Liquid Sculpey”.

以前作ったリュックは、小さい子にはどう見ても大きすぎるので、もっと小さいリュックも作りました。本体は以前の物と同様に作り、紐をオーブン粘土を細く伸ばしたもので作り、「Liquid Skulpey」で接着してあります。

Of course canteens are essential for an excursion. I made a canteen from oven-bake clay. A canteen needed bands. I made canteen bands from stretched oven-bake clay. Spread clay on a piece of aluminium foil as this as possible. Then bake it about two minute. With this baking time the clay still keeps its flexibility.

遠足なら当然水筒も必要です。本体は、オーブン粘土を丸めて適当に作りましたが、バンドが必要ですね。これを作るには、アルミフォイルの上で、オーブン粘土できるだけ薄く延ばし、フォイル後と2分ほど焼きました。焼き時間が短いので、オーブン粘土まだ柔らかいです。

Cut it into thin strips after bake.

これを切り出せば細いオーブン粘土の帯ができます。

The strips were added to the canteen by CA. The cap turned from 2mm styrene rod was also added. I need may of this. So I will duplicate it by resin casting.

上記に帯を本体に瞬接で貼り付け、2mmのスチロール棒で作った蓋をつければ完成です。これも大量に入るのでレジンで複製の予定です。

At this stage the situation of work is like this. Far more work is required to finish all figures.

とりあえず、ここまでできました。先は遠いいなー。


 

 
inserted by FC2 system