By adding ribs and plinth, the roof is finished.

丸めたスチロール板をリブで補強し、1X2mmのスチロール帯で周囲を囲めば屋根は完成です。

The guard compartment is almost finished.

これで車掌室ほぼ完成。

Next I made a brake post. I would use this for trolley Ver.3. So I would duplicate this by resin casting. It was made from 2.5X1mm styrene strip. To bent the strip I cut three grooves inside and soften the bent part heating by an i ncense stick . Heat from incense stick was ideal for this job.

ブレーキポストを作ります。これはトロッコVer.3にも使う予定なので、レジンで複製します。2.5X1mmのスチロール帯を曲げますが、このとき曲げるところの内側に3箇所ほど目立やすりで溝をほり、線香で熱しながら曲げました。

Side bar was attached on the drawing.

図面に合わせて、横桟を接着。

To make the post seem made by angle steel, I added 1.5X1mm styrene strips.

1.5X1mmのスチロール帯で構成部材をアングルにしました。

Then mounting brackets were added to the post. The brake handle was made from 1.5mm brass wire and 3mm styrene rod. The handle-fixing nut was turned from 2mm styrene hex rod. Also brake rod bearings were made. The small boltheads were cut out from 1mm styrene hex rod.

台には取り付け部分を作り、ブレーキハンドルは1.5mm真鍮線と3mmスチロール棒から製作。ブレーキハンドルの固定ナットは2mmのスチロール六角材から削りだし。後、ブレーキシャフトの軸受けを2個作りました。ボルトヘッドは1mmのスチロール六角材を輪切りにしたものです。各部には瞬接を適当に流して接合部分を丸くしてあります。

H This time I put all parts in one mould.

今回は全部の部品を一つの型で作る事にします。

Finished brake post. Additional handrails may need for guard's safety. But in old days safety regulation was not strict.

出来上がったブレーキポストです。手すりを追加しないと危なそうだけど、面倒だからこれだけでいいか。


 

 
inserted by FC2 system